FUJIKURA MCI 100 IRON SHAFTS (.370)
MCI features a new Metal Composite Technology and is a new concept applied to iron shafts. It is a carbon composite shaft which has a stainless steel inner core that adds stability to the shaft. As we know, carbon shafts are made with layers of thin carbon sheets that are tightly packed together to make a solid shaft. When the layers are wrapped together, the thicker butt end of the shaft tends to get heavier which throws off the swing balance. The traditional way of counteracting this issue was to apply extra layers of carbon sheets near the center part of the shaft. However, by doing this, it makes the shaft firmer in that area and a pure, consistent feel is lost.
To tackle this issue, Fujikura has come up with a technology that applies a solid stainless steel core within the carbon composite layers. This makes the shaft very consistent from tip to butt and also allows for a very consistent, crisp feel. The carbon layer helps absorb vibrations while the stainless steel inner core allows for a very consistent feedback at impact.
SHAFT TIP TRIMMING
The following tip trimming instructions are suggestions only. We generally do not recommend tip trimming on a driver or 3 wood shafts based on the shaft composition and how tipping could affect performance. We recommend that you consult your custom fitter or club-builder for the best tip trimming suggestions based on your individual swing and desired results.
In general, tip trimming can be used to achieve a stiffer shaft profile, lower launch, and/or lower spin. Tip trimming 1“ is equivalent to one flex. For example, if you wanted to stiffen your S flex to an X flex then you would tip trim 1”. If you prefer to play shaft in between S and X flex, you would tip trim 1/2”.